How to use KWP2000 Plus F32 the ECU REMAP Flasher

It easy to repair ECUs with KWP 2000 Plus ECU REMAP Flasher Tuning Tool, whatever the software problems or corruption. But there are some moves should be noticed, when using the KWP2000+ to read and write data.



In the most situations, it will be fine, if you were following the guidance carefully and had attention on the KWP2000 Plus operation instruction. Here is the KWP2000+ ECU chip tuning tool technical service what Xcardiag.com offers.

http://www.xcardiag.com/service/kwp2000-plus-ecu-remap-flasher-76.html



How do you use the KWP2000 PLUS?
1. You need a computer. Installing KWP2000 Plus software.
2. Connect USB cable to your PC;
3. Connect to your car via standard 16-pin OBD2 connector;
4. Supports high speed ECU flashing
5. Led indications for USB-power Car-power/rx/tx
6. Support KWP2000+ software and other KWP/ ISO software



How to Read and Write data?
1. Click read button to read out the original data
2. Click write button and select the file you want to write
3. Save the file to you HD, edit or forward it -Follow the instructions on screen
4. Switch off ignition and wait 10 seconds



Using this KWP2000 plus interface you can change maps on 44 types of ECUs. You can read original maps, edit, modify (with other software, not included) and load it again into ECU of Your car. This interface can read or write the all content of the flash memory via diagnostic socket (OBD2) of the car or directly attached to the ECU plug. Including Pocet PC Software and Dashboard Correction Software